基于连续量子级联激光器的1103.4cm–1处NH3混叠吸收光谱特性研究

由于NH3在大气气溶胶化学中具有重要作用,所以快速和精确反演NH3浓度对环境问题非常重要.本文以9.05μm的室温连续量子级联激光器(quantum cascade laser,QCL)作为光源,采用波长扫描直接吸收可调谐二极管激光吸收光谱(tunable diode laser absorption spectroscopy,TDLAS)技术,研究了QCL在1103.4 cm–1的光谱特性,获得了激光器控制的温度电流与波长的关系.设计了QCL二级温控的低压实验平台,测量氨气在1103.4 cm–1处的6条混叠吸收线,在降低压强的情况下谱线展宽变小,使混叠光谱分离,由此计算各条吸收线的线强,进一步对测量不确定度进行分析.针对混叠严重的光谱提出了低压分离单光谱精确反演气体浓度的方法,并进行了实验验证.通过与HITRAN数据库进行结果对比,得出氨气在1103.4 cm–1的实验测量线强值与数据库偏差为2.71%-4.71%,实验测量线强值的不确定度在2.42%-8.92%,极低压条件下反演浓度与实际值的偏差在1%-3%.     

On the metabolites produced by Colletotrichum gloeosporioides a fungus proposed for the Ambrosia artemisiifolia biocontrol; spectroscopic data and absolute configuration assignment of colletochlorin A

Ambrosia artemisiifolia L. is responsible for serious allergies induced on humans. Different approaches for its control were proposed during the COST Action FA1203 “Sustainable management of Ambrosia artemisiifolia in Europe” (SMARTER). Fungal secondary metabolites often show potential herbicidal activity. Three phytotoxins were purified from the fungal culture filtrates of Colletotrichum gloeosporioides, isolated from infected leaves of A. artemisiifolia. They were identified by spectroscopic and chemical methods as colletochlorin A, orcinol and tyrosol (1, 2 and 3). The absolute configuration 6’R to colletochlorin A was assigned for the first time applying the advanced Mosher’s method. When assayed by leaf-puncture on A. artemisiifolia only 1 caused the appearance of large necrosis. The same symptoms were also induced by 1 on ambrosia plantlets associated with plant wilting. On Lemna minor, colletochlorin A caused a clear fronds browning, with a total reduction in chlorophyll content.     

Smarandache函数在两数列上的下界估计

设S(n)是Smarandache函数,其中n是一正整数.讨论Smarandache函数S(n)在数列F((2k),1)=F(n,1)=n2n+1(n=2k)与数列G(2n,1)=(2n)2n+1上的下界估计.基于初等方法证明了:当偶数n≥6时,有S(F((2k),1))=S(F(n,1))≥6×2n+1;当n≥4时,有S(G(2n,1))≥6×2n+1.     

基于ELM算法的羊肉水分含量的快速无损检测

在近红外光谱900-1700nm的波长范围内采集南疆羊肉的光谱数据,来研究水分含量的快速无损检测.为减弱非目标因素对光谱的影响,采用SNV和去趋势法对光谱数据进行预处理.为降低建模的复杂度,去除共线性的影响,采用连续投影算法和相关系数法相结合选取8个特征波长变量,最后使用PLS和ELM算法分别进行建模.实验表明,与采用全光谱波段建模相比,采用特征波长变量建模,PLS和ELM算法的运行时间都大大缩短,并且在运行时间和预测精度上,ELM算法均优于PLS算法.ELM算法采用8个特征波段变量建模,预测精度达到0.9768,均方误差为4.4291e-04,相关系数为0.7603,运行时间可控制在1e-04s之下,这可为研发羊肉水分含量的便携式检测装置提供理论参考.     

Study of nucleon-nucleon and alphanucleon elastic scattering by the Manning-Rosen potential

Although often used in molecular dynamics, in this work the Manning–Rosen potential is parameterized to compute the scattering phase shifts for the nucleon–nucleon and the alpha-nucleon systems by exploiting the standard phase function method. We obtain excellent agreement in phase shifts with the more sophisticated calculations up to partial waves ${\ell }=2.$     

HL-2M装置等离子体放电反馈控制系统

通过对HL-2M装置极向场线圈的参数和初始等离子放电控制需求的分析，基于实时采集系统和反射内存实时数据传输的先进控制集成技术，完成了整个HL-2M初始等离子体放电反馈控制系统的设计。新系统实现了稳定的1ms控制周期和实时数据传输，同时解决了实时控制周期和数据传输的延迟。实验结果表明新设计的等离子控制系统能满足初始等离子体极向场线圈电流控制的需求。     

Reentrant behavior of magnetic ordered phase in spin-crossover solids with quenched disordered ligand field

The Ising-like model of spin-crossover solid compounds with quenched random ligand field has been investigated by the mean-field (infinite-range) approximation. An exact solution for the problem is found within the replica formalism. The magnetic diagrams are obtained; the relations between the intermolecular coupling and the temperature as well as the reentrant phenomena of the magnetic ordered phase are discussed.     

湍流大气传输中跟踪抖动对远场影响的仿真研究

分析了跟踪抖动对湍流大气传输远场光斑的影响。基于麦克斯韦电磁场理论,采用大气相干长度对大气湍流进行描述,推导了发射光束因跟踪抖动导致光轴偏离的远场表达式。在此基础上,利用相位屏法模拟抖动引起的倾斜相位和大气折射率起伏引起的相位调制,并采用低频补偿的功率谱反演法对传输过程进行了数值仿真。分析了不同跟踪抖动、湍流强度条件下远场光斑质心脱靶量的变化,以及不同尺寸模拟目标的回波概率。分析结果表明,在传输距离为10 km时,强湍流造成的远场光斑脱靶量可达几十μrad;当跟踪抖动较大时,湍流强弱对脱靶量影响差别很小。最后,对一定尺寸的模拟目标,从探测回波概率的角度给出了发射系统跟踪抖动量的控制范围。     

光与原子纠缠存储寿命与磁场噪声关系的实验研究

在冷原子系综中,利用自发拉曼散射过程产生光与原子纠缠,测量了恢复效率随存储时间的关系。实验结果显示在没有施加轴向磁场时的存储寿命仅仅只有40μs。而在施加轴向磁场的情况下,存储时间在50μs以后甚至在400μs时都可以测量到明显的恢复信号,存储寿命明显高于100μs,远高于未施加轴向磁场时的情况。对这个实验现象进行分析认为:原子所处的环境中存在磁场噪声的影响,当没有轴向磁场时,噪声会扰乱自旋波信号的相位;当有轴向磁场时,磁场噪声对自旋波相位的影响便被抑制了。     

Engineering nanostructures of CuO-based photocatalysts for water treatment: Current progress and future challenges

Nowadays, increasing extortions regarding environmental problems and energy scarcity have stuck the development and endurance of human society. The issue of inorganic and organic pollutants that exist in water from agricultural, domestic, and industrial activities has directed the development of advanced technologies to address the challenges of water scarcity efficiently. To solve this major issue, various scientists and researchers are looking for novel and effective technologies that can efficiently remove pollutants from wastewater. Nanoscale metal oxide materials have been proposed due to their distinctive size, physical and chemical properties along with promising applications. Cupric Oxide (CuO) is one of the most commonly used benchmark photocatalysts in photodegradation owing to the fact that they are cost-effective, non-toxic, and more efficient in absorption across a significant fraction of solar spectrum. In this review, we have summarized synthetic strategies of CuO fabrication, modification methods with applications for water treatment purposes. Moreover, an elaborative discussion on feasible strategies includes; binary and ternary heterojunction formation, Z-scheme based photocatalytic system, incorporation of rare earth/transition metal ions as dopants, and carbonaceous materials serving as a support system. The mechanistic insight inferring photo-induced charge separation and transfer, the functional reactive radical species involved in a photocatalytic reaction, have been successfully featured and examined. Finally, a conclusive remark regarding current studies and unresolved challenges related to CuO are put forth for future perspectives.